Plunger Dish fits PlumbPak PP845-7
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Plunger dish designed to fit a 6" plunger with a protruding 3" sleeve such as PlumbPak PP845-7 Print out a tester…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 451
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Share Alike
Plunger dish designed to fit a 6" plunger with a protruding 3" sleeve such as PlumbPak PP845-7
Print out a tester first if unsure of the fit.
F3D and STEP files are included, however this isnot a parametric design: The revolved form was hand-sculpted to make it printable. It's probably easier just to scale the model to fit a larger/smaller plunger.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
15%
Filament: Overture PETG Space Gray
Notes:
This will print without any supports. There is one 45.5deg angle near the top some slicers may complain about however this prints fine even in PETG.
Using Fusion 360
- Create a sketch to represent the inside form Enter Form workbench Create -> Revolve from sketch Delete half of the faces of the top dome Thicken to 1.8mm - make sure direction is away from the inside Use slide edge and bevel edge tools to eliminate steep overhangs from the outer shell Flatten the bottom
Category: Bathroom