Plunger Dish fits PlumbPak PP845-7
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Plunger dish designed to fit a 6" plunger with a protruding 3" sleeve such as PlumbPak PP845-7 Print out a tester…
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 0
- Makes
- 0
- Views
- 451
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Share Alike
Plunger dish designed to fit a 6" plunger with a protruding 3" sleeve such as PlumbPak PP845-7
Print out a tester first if unsure of the fit.
F3D and STEP files are included, however this isnot a parametric design: The revolved form was hand-sculpted to make it printable. It's probably easier just to scale the model to fit a larger/smaller plunger.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
15%
Filament: Overture PETG Space Gray
Notes:
This will print without any supports. There is one 45.5deg angle near the top some slicers may complain about however this prints fine even in PETG.
Using Fusion 360
- Create a sketch to represent the inside form Enter Form workbench Create -> Revolve from sketch Delete half of the faces of the top dome Thicken to 1.8mm - make sure direction is away from the inside Use slide edge and bevel edge tools to eliminate steep overhangs from the outer shell Flatten the bottom
Category: Bathroom