1 / 11
608 Bearing (Parametric Fusion360 File, print in place) — zdjęcie 1
1 / 11

608 Bearing (Parametric Fusion360 File, print in place)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A print in place 608 ball bearing that can be parametrically modified thanks to the included Fusion 360 file.

Ocena
5 / 5
Polubienia
71
Pobrania
651
Wydruki
4
Wyświetlenia
2447
Oceny
5

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

I wanted to make my own print-in-place 608 ball bearing for my Ikea Samla Drybox so that all the necessary parts can be printed down to the IkeaBox.

I modeled it in Fusion360 and so I can offer it to you as an .f3d file so you can easily change the created custom parameters yourself.

 

Parameters:

In Fusion360, the individual parameters are very easy to change so that you can adapt the ball bearing to your needs or your printer.

 

 

Printing parameters:

Since the roller bearings are very fine and the gap should be as small as possible, I've had the best experience of only printing at about 50% print speed. The finer the layer heights the better, I printed it with 0.1mm layer height and it fits very well.

  • 0.1 or less layer height
  • 50% print speed

 

Post Processing after printing:

So that the roller bearings do not rub against a side wall, they are offset inwards on both sides. So that you can do this with the printer, I put a support ring underneath with a distance of 0.2mm.

This ring is very easy to remove with a stanlay knife by carefully driving the tip into the groove and levering out the ring.

 

 

 

 

The inner ring can be fixed nicely with a Torx T50 to make it work.

I then very carefully got the roller bearings running with pointed tweezers.

 

 

 

 

 

If the ball bearing then runs reasonably well, I have had the experience that I have carefully held it to the chuck of the running drill press so that it runs in. You can also use a cordless screwdriver with a clamped T50 Torx.

Then some silicone grease or lubricating grease of your choice, run this in a bit and it's done :)

 

 

 

 

 

 

 

happy printing and please post a make, i would really appreciate it :)

Tagi