BEER LID / BOTTLE CAP
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
BEER LID / BOTTLE CAP
- Ocena
- 5 / 5
- Polubienia
- 37
- Pobrania
- 287
- Wydruki
- 2
- Wyświetlenia
- 1264
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
It was designed as a beer cap, but theoretically fits any standard bottle.
It is not water resistant or beer resistant d-_-b.
I used PETG so I used a scaling of +1.2% and it fits perfectly. (it depends on the material used; somewhere between +0.8% and +1.5% for PETG). I do not recommend printing with PLA if you want to keep the beer somewhere in the sun or in the fridge.
Please leave a like if you like it. If you don't like it, write in the comments what the problem is and I will try to solve it.
IMPORTANT NOTE:
If you want to sell 3D prints based on my designs legally, please become a Patreon on my page and get early access to all the new designs:
www.patreon.com/levytek
All of my Designs are covered by a Creative Commons Non-Commercial License. The sale of prints using my designs is the sole right of myself, the designer, and my active Patreons to do so. Please understand that every design is workday, and multiple prototype prints to ensure quality.
THX!
3D PRINTING SETTINGS
Resolution:
0.2 mm
Infill:
0-15%
Walls:
3
Material:
PETG