Stand for 1U devices.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It's a stabilizer that clamps around the bottom of a 1U device such as a network switch.
- Ocena
- 4 / 5
- Polubienia
- 0
- Pobrania
- 22
- Wydruki
- 1
- Wyświetlenia
- 148
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
It's a stabilizer that clamps around the bottom of a 1U device such as a network switch. Most applications will require you to print two per device for stability.
Indentations on bottom and between uprights are for non-slip pads. I use 1.5mm thick non-slip silicone material that I found on amazon, cut into 20mm squares. An additional pad on one of the uprights will prevent the print from slipping off if device is picked up.
I print these in PLA with triangle infill at 10% and two walls. Very flexible but tough.