"DINish" RPi mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Din mounts for rpi are great as long as there are other devices that can fill out the rail, but a pi din mounted all…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 283
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Din mounts for rpi are great as long as there are other devices that can fill out the rail, but a pi din mounted all on it's own takes more work and uses up more mounting real estate. I was faced with such a situation while building my cnc controller box. I decided the best spot for the pi was the top corner, far away from any other DIN mount devices. So I designed this alternative 'dinnish' style pi mount to simplify install and make the footprint on the backplane as small as possible.
It is an easy print; no supports or other tricks required. Since mounting hole spacings for full sized rpi boards have not changed, it will work with any standard pi (rpi1-4). Use 4@ short M3 bolts to secure the pi board to the mount. Then drive 2 self drilling screws (or predrill and drive #8 self tapping screws) through the 2x 4mm diameter holes and in to a flat surface to secure it.
Category: Electronics