1 / 1
Feet for Bosch Gravity Rise Saw Stand — zdjęcie 1

Feet for Bosch Gravity Rise Saw Stand

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I designed these feet to protect the bar on my Bosch T4B Gravity Rise miter saw stand when the saw is being stored…

Ocena
0 / 5
Polubienia
1
Pobrania
31
Wydruki
0
Wyświetlenia
284
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I designed these feet to protect the bar on my Bosch T4B Gravity Rise miter saw stand when the saw is being stored vertically (love the stand BTW). They also help take some of the heavy load off of the threaded feet when tilting the saw up, prevent marring the floor when using the saw inside, and allow easier positioning of the saw by sliding it around while in the vertical position. Printed in nylon, they are durable, mar free, slippery, and flexible enough to slip over the large tubing.

Print out 4x feet as oriented in the STL. The bottom is intentionally not filleted to help with bed adhesion; the bottom edges can be deburred by hand if desired (not required). Each foot is clamped to the bars using a pair of 3x16mm screws and nuts.

Also see my 2.5" vacuum adapter for the Bosch 12" slider saw here: https://www.thingiverse.com/thing:3212209

Print Settings

Printer Brand:

Anet

Printer:

A8

Rafts:

No

Supports:

No

Resolution:

0.2mm

Infill:

30%

Filament: Taulman Bridge Nylon Black


Notes:

Use what works for you. My setup looked like this...

0.4mm nozzle

0.45mm line width

5 walls

8 top/bottom layers

30% infill

5 line brim

boro glass bed (+elmers glue stick)

270C/110C

44C enclosure

60/30 mm/sec

I designed the thickness to go with 5 walls at 0.45mm width (for a 2.25mm total wall thickness). Don't go thinner than 2.25mm, otherwise the feet will be much weaker (you'll get infill inside heavy load bearing areas). Thicker is OK... just takes longer and uses more filament.

Note: My a8 is not stock... do not attempt to print nylon with a stock a8 hotend!

Category: Tools

Tagi