1 / 3
Delta-P fan duct V2R2.2-duct X2-Endoscope — zdjęcie 1
1 / 3

Delta-P fan duct V2R2.2-duct X2-Endoscope

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I made this remix to fit a 7mm camera module while still keeping the two LED's at the sides.

Ocena
5 / 5
Polubienia
34
Pobrania
124
Wydruki
3
Wyświetlenia
1277
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

You can read my full guide on how to make this and set it up over at Instructables. Made for 7mm camera modules (some filing might me needed to get a snug fit)

Print in PETG, 0.2mm layer height. 

If you make this, I would love to see how your view turn out!

Installation Instructions by @teookie, presented here only for your convenience:

Note that these steps show @teookie's geometry (not my remixed geometry)

If you are still reading this, congratulations, you are serious about 3D printing! 

Happy printing!