1 / 3
Delta-P fan duct V2R2.2-duct X2-Endoscope — image 1
1 / 3

Delta-P fan duct V2R2.2-duct X2-Endoscope

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

I made this remix to fit a 7mm camera module while still keeping the two LED's at the sides.

Rating
5 / 5
Likes
34
Downloads
124
Makes
3
Views
1,277
Reviews
3

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

You can read my full guide on how to make this and set it up over at Instructables. Made for 7mm camera modules (some filing might me needed to get a snug fit)

Print in PETG, 0.2mm layer height. 

If you make this, I would love to see how your view turn out!

Installation Instructions by @teookie, presented here only for your convenience:

Note that these steps show @teookie's geometry (not my remixed geometry)

If you are still reading this, congratulations, you are serious about 3D printing! 

Happy printing!