Pico Setup Ruler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 2" x 1" ruled square for setting distances and scribing lines.
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 33
- Wydruki
- 1
- Wyświetlenia
- 270
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
This model has 1/16" rulers on most surfaces and notches every 1/8" on almost all surfaces.
It can be used to set router bit depth, router plane blade depth, tablesaw width and height, etc.
You can use a pencil in a notch to draw lines.
This model was designed for a 0.15mm layer height. You don't need much infill, 15% is fine, I've used 5% with no issues (but very little speed up so why bother).
I had real issues with the corners curling up off the print bed so I added tabs to keep them down. It works for my printer. They flex right off, no need for tools.
I sand (lightly! with 220 grit paper on flat surface (like a tablesaw)) the non print bed surfaces to smooth them out. Ironing might work but haven't tried it.