Neopixel tank shroud fan cover

This is a remix of the EVA 3 Tank shroud with 2 pcb button neopixel, one in the logo and another to the print part.

For the top led, one file takes M3 x 3mm heatinserts and the other screws into the plastic.

For the bottom led it was a tab to hold it

This is my klipper config to enable the NeoPixel green on full time and turn on an off the white light:

Create a file named Neopixel.cfg

In there:

[neopixel board_rgb]
pin: PB0
chain_count: 2
color_order: GRBW
initial_RED: 0
initial_GREEN: 0
initial_BLUE: 0
initial_WHITE: 0

[delayed_gcode Welcome_0]
initial_duration: 0
gcode:
 SET_LED LED=board_rgb RED=0.0 GREEN=0.0 BLUE=0.0 WHITE=0.0

[delayed_gcode Welcome_1]
initial_duration: 0.1
gcode:
 SET_LED LED=board_rgb RED=0 GREEN=0.1 BLUE=0 WHITE=0.0 INDEX=1 TRANSMIT=1

[delayed_gcode Welcome_2]
initial_duration: 0.2
gcode:
 SET_LED LED=board_rgb RED=0 GREEN=0 BLUE=0 WHITE=1.0 INDEX=2 TRANSMIT=1

[gcode_macro LED_OFF]
gcode:
 SET_LED LED=board_rgb RED=0 GREEN=1 BLUE=0 WHITE=0 INDEX=1 TRANSMIT=0
 SET_LED LED=board_rgb RED=0 GREEN=0 BLUE=0 WHITE=0 INDEX=2 TRANSMIT=1

[gcode_macro LED_ON]
gcode:
 SET_LED LED=board_rgb RED=0 GREEN=1 BLUE=0 WHITE=0 INDEX=1 TRANSMIT=0
 SET_LED LED=board_rgb RED=0 GREEN=0 BLUE=0 WHITE=1 INDEX=2 TRANSMIT=1

On the Printer.cfg add:

[include Neopixel.cfg]

On the Macro to start the print:

gcode:
 LED_ON

On the Macro to end the print:

gcode:
 LED_OFF

I'm no expert on klipper but this conf worked for my V-core

Any suggestion is wellcome

Enjoy