1 / 3
NR200 15 mm Slim Fan Mounting Pins — zdjęcie 1
1 / 3

NR200 15 mm Slim Fan Mounting Pins

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Allows mounting 15 mm thick fans on top of CoolerMaster NR200 (P) case with optional grille

Ocena
5 / 5
Polubienia
32
Pobrania
373
Wydruki
1
Wyświetlenia
2809
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Share Alike

Mount slim fans on top of Cooler Master NR200P case. 

I wanted my PSU to hang higher inside the case to help with cable management, however that caused the power plug to collide with the stock 25 mm thick fans. So I made this to install slim Noctua fans (15 mm).

Two versions are included:

  • Pin_Screw.stl replaces the stock pins - use those to install stock grills with the screws shipped with the case; those will allow for about 5 mm more clearance than the original pins,
  • Pin_NoScrew.stl sits practically flush with the fan body; should give you about 10 mm more clearance compared to the original mounting hardware. Spinning fan blades are sharp - watch your fingers ;-)

My top fans pull the hot air out from the case, so I'd recommend printing this using PETG or similar material that won't soften as much under higher temperature. I printed prototype of the NoScrew version in PLA and it didn't seem too damaged after a few weeks inside the case, but you know, better safe than sorry!

Tagi