NR200 15 mm Slim Fan Mounting Pins
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Allows mounting 15 mm thick fans on top of CoolerMaster NR200 (P) case with optional grille
- Rating
- 5 / 5
- Likes
- 32
- Downloads
- 372
- Makes
- 1
- Views
- 2,804
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
Mount slim fans on top of Cooler Master NR200P case.
I wanted my PSU to hang higher inside the case to help with cable management, however that caused the power plug to collide with the stock 25 mm thick fans. So I made this to install slim Noctua fans (15 mm).
Two versions are included:
- Pin_Screw.stl replaces the stock pins - use those to install stock grills with the screws shipped with the case; those will allow for about 5 mm more clearance than the original pins,
- Pin_NoScrew.stl sits practically flush with the fan body; should give you about 10 mm more clearance compared to the original mounting hardware. Spinning fan blades are sharp - watch your fingers ;-)
My top fans pull the hot air out from the case, so I'd recommend printing this using PETG or similar material that won't soften as much under higher temperature. I printed prototype of the NoScrew version in PLA and it didn't seem too damaged after a few weeks inside the case, but you know, better safe than sorry!