KREG Precision Router Lift +BOSCH (GMF1400, 1617) Dust Remover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed for the KREG (PRS5000) precision router lift paired with BOSCH (GMF1400, 1617) router motor 3.5"
- Ocena
- 5 / 5
- Polubienia
- 39
- Pobrania
- 192
- Wydruki
- 1
- Wyświetlenia
- 3627
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Update 03.09.2023: Improved "click and clean" ergonomics.
Printer brand: Flying Bear
Printer: Ghost6
Rafts: No
Supports: Yes (only "base" detail)
Resolution: 0.2
Infill: 100%
Filament brand: Esun
Filament color: red, light blue
Filament material: PLA+
Slicer: Ultimaker Cura 5.2.1
Printing temperature: 215 Celsium
Build plate: 60 Celsium
Print speed: 60 mm/s
Fan speed 100%
Postprinting: may require sanding or edge trimming with a knife.
Assembling: Glue the “ring” into the groove on the “plate”. Install the “base” on the KREG lift with the router motor removed. After installing the KREG lift in the table, loosen the 4 mounting screws and lift the router motor up to accurately center the “base”. The “plate” is installed with the pins up. When the vacuum cleaner is in operation, the pins rest against the KREG Original Inserts and do not allow the “plate” to rise under the action of vacuum.
ATTENTION! IMPORTANT!
The height of the pins is designed specifically for the dimensions of the KREG Original Inserts.
Use only Router motor (3.5 inch).
The router motor (3.5") in the KREG router lift should be installed in such a way that, when fully lifted, the moving parts of the lift do not reach the “base”. Otherwise, the part will crush.
P.S. Tested: Blind groove (all chips fall down) 10*10 about 2 meters long. This thing really works! Inside the router table (cabinet) there were only a few chips, and before there were "snowdrifts". Now you can even work in the bedroom!