Guitar Amplifier Organizer (vase mode!)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Utilize vase mode, fuzzy skin, and filament swapping to make a great looking bit of functional desk art.
- Ocena
- 5 / 5
- Polubienia
- 206
- Pobrania
- 570
- Wydruki
- 8
- Wyświetlenia
- 3097
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
This is fun little pen holder in the shape of a guitar amp half stack. Pay attention to the settings below, and you should be able to print this very quickly and have a great result.
I've also included a “blank” bottom template if you want to add your own name.
Print Instructions:
Black-Cabinet__Vase
Use vase mode! yaaay for quick prints. Enable the “fuzzy skin” settings in your slicer to get a pretty authentic looking tolex finish on the amp. Quick tip for Cura 5 users- there's a bug that doesn't allow you to use both fuzzy and vase mode at the same time. Try Cura 4 if you run into that issue.
Gold-Controls
Print normally, with the knobs facing the sky. Use supports
Black-Handle
Print two of these normally, no supports needed.
Multi-Bottom & Multi-Top
(front meshes & white border on the amp)
- These can be printed together.
- Disable top & bottom layers.
- Use a grid infill of 80%
- Wall line Count of 2
- Set your slicer to pause & request a filament change around layer 4 when the borders and logo start to print.
- Load black filament first, and then swap to white when needed.
Aren't equipped to change filament at a specific layer height? I've included a folder where you can print those items on their own, but it will be trickier to assemble.
Once it's all printed, superglue the bits together and enjoy!
Post a make! I'd love to see them!