Guitar Amplifier Organizer (vase mode!)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Utilize vase mode, fuzzy skin, and filament swapping to make a great looking bit of functional desk art.
- Rating
- 5 / 5
- Likes
- 206
- Downloads
- 570
- Makes
- 8
- Views
- 3,097
- Reviews
- 7
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial
This is fun little pen holder in the shape of a guitar amp half stack. Pay attention to the settings below, and you should be able to print this very quickly and have a great result.
I've also included a “blank” bottom template if you want to add your own name.
Print Instructions:
Black-Cabinet__Vase
Use vase mode! yaaay for quick prints. Enable the “fuzzy skin” settings in your slicer to get a pretty authentic looking tolex finish on the amp. Quick tip for Cura 5 users- there's a bug that doesn't allow you to use both fuzzy and vase mode at the same time. Try Cura 4 if you run into that issue.
Gold-Controls
Print normally, with the knobs facing the sky. Use supports
Black-Handle
Print two of these normally, no supports needed.
Multi-Bottom & Multi-Top
(front meshes & white border on the amp)
- These can be printed together.
- Disable top & bottom layers.
- Use a grid infill of 80%
- Wall line Count of 2
- Set your slicer to pause & request a filament change around layer 4 when the borders and logo start to print.
- Load black filament first, and then swap to white when needed.
Aren't equipped to change filament at a specific layer height? I've included a folder where you can print those items on their own, but it will be trickier to assemble.
Once it's all printed, superglue the bits together and enjoy!
Post a make! I'd love to see them!