E3DBuggy - Spider Mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution
I hope this will pose a good challenge for fans of E3DBuggy fans. I used Fusion 360 to design and add in a simple-looking resting spider on the buggy's roof. This should help me see if my printer is steady enough. I will have to re-print again (see my makes) even though it works.
Do pardon my painting skill -I am sure you can do a better outcome than what I did.
Cura settings are included in the last few photos. It took 2 hrs 50 mins to print, including warming the nozzle and bed.
I printed this on my Anycubic Kossel that has been upgraded with a SKR2 (B) board and TMC2209 drivers. There is an enclosure and an inner cardboard wall. The inner cardboard wall really helps in stabilizing every print that I did.
Maybe slightly lowering the nozzle temperature, adjusting the retraction distance up a little, and reducing the retraction speed a little might give a better finish. I wanted to try using a skirt but did not have the time for a second run as I have some other prints to do.