E3DBuggy - Spider Mod
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This E3dBuddy has a spider resting on its roof. This model can be printed without support, with all the 8 legs.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 12
- Makes
- 1
- Views
- 144
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution
I hope this will pose a good challenge for fans of E3DBuggy fans. I used Fusion 360 to design and add in a simple-looking resting spider on the buggy's roof. This should help me see if my printer is steady enough. I will have to re-print again (see my makes) even though it works.
Do pardon my painting skill -I am sure you can do a better outcome than what I did.
Cura settings are included in the last few photos. It took 2 hrs 50 mins to print, including warming the nozzle and bed.
I printed this on my Anycubic Kossel that has been upgraded with a SKR2 (B) board and TMC2209 drivers. There is an enclosure and an inner cardboard wall. The inner cardboard wall really helps in stabilizing every print that I did.
Maybe slightly lowering the nozzle temperature, adjusting the retraction distance up a little, and reducing the retraction speed a little might give a better finish. I wanted to try using a skirt but did not have the time for a second run as I have some other prints to do.