PrintBone PEX Slide Files
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a modification of the slide from PieterB's PrintBone. It has been changed to fit PEX tubing.
- Ocena
- 5 / 5
- Polubienia
- 36
- Pobrania
- 186
- Wydruki
- 3
- Wyświetlenia
- 1533
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution
This is a modified version of the slide from PieterB's “The PrintBone: a fully printable playable trombone."
Link here: https://www.printables.com/model/80020-the-printbone-a-fully-printable-playable-trombone
Because I live in America, the correctly sized PVC pipes I needed to print PieterB's slide are not available. Fortunately, he provided the OpenSCAD parametric files for the model and I was able to change the tube sizes to what I could find in the US (With a lot of help from PieterB).
This version fits the ½ and ¾ inch PEX tubing/piping you can find at the hardware store here in the United States. My hardware store sells them in 5 ft lengths, which are about the perfect length so there isn't too much waste. I used the blue tubing, but red and white should work just the same.
I cut the tubing to approximately 26-27 inches in length, using my own trombone as reference. From there, I shaved off a bit from the ends until the tuning was about right.
I provided the stockings generated by the OpenSCAD program, but they seemed to be too thick, and I found that the PEX had good enough tolerances that the trombone could create a decent sound without them.
There is a file for a large shank inner slide grip. However, because the inner diameter of the ½ in. PEX is a little small, I could only ever get the small shank leadpipe to fit.
For the bell, I printed PieterB's “The PrintBone v1.1: a fully printable playable trombone."
Link here: https://www.printables.com/model/80017-the-printbone-v11-a-fully-printable-playable-tromb
For the mouthpiece, I used this 6.5 AL model: https://www.thingiverse.com/thing:3225616
I also printed a 1.5G using PieterB's Mouthpiece Customizer: https://www.printables.com/model/80021-improved-trombone-mouthpiece-customizer
Printing Instructions:
To print this, I followed the instructions and print setting suggestions from the original model.
I did add a raft to each of the parts because I found that some of them had a tendency to warp, and I printed the leadpipe with vase mode.