Adjustable z-axis stabilizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Since I have extended my Kywoo3D Tycoon Max to 45 cm print height, I wanted a adjustable Z-axis stabilizer and made…
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 622
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Since I have extended my Kywoo3D Tycoon Max to 45 cm print height, I wanted an adjustable Z-axis stabilizer and made this one.
Part 1 and 2 fit most printers. I created an extra one for the unmodified Kywoo3D Tycoon, but didn't test it myself.
Part 1 works for both versions.
2x M3x8
2x M3 t-nuts
2x M3x16
2x M3 nuts
1x 608 ZZ ball bearing
When attaching, it is recommended to set the hotend to the highest possible position and then adjust the Z-Stabilizer and screw tight. Otherwise, you could bend your threaded spindle when printing!
I'm always open to comments for improvement!
Print Settings
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0.2
Infill:
15
Filament: NEXBERG ASA Black
Notes:
At the moment I print a lot in ASA (0.6 nozzle), so I also printed this part, but it can also be printed in PETG. The 608 zz ball bearing goes in a little tight to keep it in place, maybe use a little grease. If there are any stability issues with PETG, just write a comment and I will change the bearing hole size by 0.1-0.2 mm.
Category: 3D Printer Parts