Stability Feet for 'Prusa Steel Sheet Holder' +V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an addition to the 'Prusa Steel Sheet Holder 2er, 3er and 4er' to improve stability. Added a second version!
- Ocena
- 4,926 / 5
- Polubienia
- 405
- Pobrania
- 2219
- Wydruki
- 119
- Wyświetlenia
- 6433
- Oceny
- 121
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This is an addition to the 'Prusa Steel Sheet Holder 2er, 3er and 4er' to improve stability.
Problem: the surface area of the 2 slot version of the sheet holder is small and the sheets are tall, this causes the holder to fall on the side if hit.
Solution: these two feet help to improve the stability increasing the surface area, extending it to both sides.
2021 Update - 2er Feet V2
Improved model for the 2 slot version.
- Reduced tolerances for the hexagonal pins to improve the snap-fit
- Extended the surface area up to the external sides to avoid the bending of the sheet holder and improve the stability
- Nicer seamless line between the sheet older and the table
- Added .3mf file
2021 Mini extension (+2 mini's sheets)+ stability feet
Print instructions
-Gyroid Infill 20% min. recommended.
-3 Perimeters
-PLA or PETG, print with the same material of the sheet holder.
-Print x2 pieces min.
The .gcode contains 2 feet already, in case you pick the stl file print two pieces then