Stability Feet for 'Prusa Steel Sheet Holder' +V2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is an addition to the 'Prusa Steel Sheet Holder 2er, 3er and 4er' to improve stability. Added a second version!
- Rating
- 4.926 / 5
- Likes
- 406
- Downloads
- 2,220
- Makes
- 119
- Views
- 6,437
- Reviews
- 121
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
This is an addition to the 'Prusa Steel Sheet Holder 2er, 3er and 4er' to improve stability.
Problem: the surface area of the 2 slot version of the sheet holder is small and the sheets are tall, this causes the holder to fall on the side if hit.
Solution: these two feet help to improve the stability increasing the surface area, extending it to both sides.
2021 Update - 2er Feet V2
Improved model for the 2 slot version.
- Reduced tolerances for the hexagonal pins to improve the snap-fit
- Extended the surface area up to the external sides to avoid the bending of the sheet holder and improve the stability
- Nicer seamless line between the sheet older and the table
- Added .3mf file
2021 Mini extension (+2 mini's sheets)+ stability feet
Print instructions
-Gyroid Infill 20% min. recommended.
-3 Perimeters
-PLA or PETG, print with the same material of the sheet holder.
-Print x2 pieces min.
The .gcode contains 2 feet already, in case you pick the stl file print two pieces then