1 / 5
Screen Holder for Renogy 500A battery monitor. — zdjęcie 1
1 / 5

Screen Holder for Renogy 500A battery monitor.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

45 degree mount for the screen of Renogy 500A battery monitor/coulometer/shunt.

Ocena
5 / 5
Polubienia
13
Pobrania
152
Wydruki
2
Wyświetlenia
990
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

21/10/2024:

Made a V2. Hole is now 94.2mmx57.2mm. Print it like a little house, no supports. Printed the closed one seems pretty good. Haven't tried the open one.

29/11/2022:

Screen holder at 45 degrees. Opening is exactly 94mm x 57mm as the instructions indicate the hole should be.

The vertical height for the opening was fine, with a little room for movement without squishing the tabs too much. However I did do a very small amount of filing on the sides so the screen would fit. This may be due to my printer over extrusion in corners (linear advance not on).

Give it 3 or 4 walls, (I gave it 4 for lots of strength) and you'll have plenty of material you can file if required. Opening gets covered anyway.

Screw holes are 3mm, drill them out if required.

I printed with supports, I think it needs them but maybe not. See the picture.