1 / 5
Screen Holder for Renogy 500A battery monitor. — image 1
1 / 5

Screen Holder for Renogy 500A battery monitor.

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

45 degree mount for the screen of Renogy 500A battery monitor/coulometer/shunt.

Rating
5 / 5
Likes
13
Downloads
152
Makes
2
Views
990
Reviews
2

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution

21/10/2024:

Made a V2. Hole is now 94.2mmx57.2mm. Print it like a little house, no supports. Printed the closed one seems pretty good. Haven't tried the open one.

29/11/2022:

Screen holder at 45 degrees. Opening is exactly 94mm x 57mm as the instructions indicate the hole should be.

The vertical height for the opening was fine, with a little room for movement without squishing the tabs too much. However I did do a very small amount of filing on the sides so the screen would fit. This may be due to my printer over extrusion in corners (linear advance not on).

Give it 3 or 4 walls, (I gave it 4 for lots of strength) and you'll have plenty of material you can file if required. Opening gets covered anyway.

Screw holes are 3mm, drill them out if required.

I printed with supports, I think it needs them but maybe not. See the picture.