1 / 4
RatRig V-Core 3/3.1 legacy slim belt tensioner — zdjęcie 1
1 / 4

RatRig V-Core 3/3.1 legacy slim belt tensioner

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A simple but effective belt tensioning system for legacy V-Core 3 and 3.1

Ocena
4 / 5
Polubienia
40
Pobrania
170
Wydruki
1
Wyświetlenia
2658
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

Belt tensioner to be mounted on the frame of the V-Core3 and 3.1 legacy.

It allows to remove EVA 2 and 3 heavy belt tensioner from the carriage and make tensioning much easier by placing tension screws on the front.

It replaces stock idler plates.

  • Print material: PETG - ABS/ASA if enclosed;
  • Print instructions: Place pieces as showed in the picture. Print left and right “idler_tensioner” pieces selecting “slicer tolerance” to “exclusive”;
  • Supports: no;

BOM:

  • n.4 M3x25mm bolts;
  • n.2 M3x20mm bolts;
  • n.2 M3 washers;
  • n.6 M3 nylock nuts;
  • n.4 M4x10mm bolts;
  • n.4 M4 T-nuts.

The design make use of those stock components:

  • n.4 RatRig M6 x0mm bolts (ratrig stock);
  • n.4 RatRig M6 T-nuts;
  • n.4 RatRig M5 conical bolts;
  • n.2 RatRig 3 or 3.1 idlers;

Print two idlers 5mm adapters to center M3 screw into 5mm idler bearings and two top corner plates (they are symmetrical).

If you like my design and you are happy with it, please consider donating a coffee to justify the time and effort in researching/designing.

Enjoy it!

Tagi