Parkside X20V battery in Ferrex tool (with reverse side entry)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an adapter to be able to use a Parkside battery in a Ferrex tool. The battery enters from the opposite side of t
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 368
- Wydruki
- 1
- Wyświetlenia
- 2391
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
All parts were printed with PETG with a resolution of 0.28mm and with supports.
In addition to the printed parts, you will need 4 screws identical to those in the photo plus 3 BX2091C terminals
and 3 Spade 6.3mm male terminals
Three wires of about 70mm are also needed.
The positive and negative wires should be 16AWG. The third wire can be thinner as it serves to transmit the temperature sensor signal and does not need significant current.
The slots for inserting the terminals are very tight so they can stay in place until you apply the glue, so it takes a little effort and patience to insert the terminals.
I recommend hot glue to secure the terminals in place.
The terminals must be placed as shown in the photos.
If you want an adapter where the battery goes through the same side as the original tool, check out this model:
https://www.printables.com/model/329087-parkside-x20v-team-battery-in-ferrex-tool-battery-
Do not use the Ferrex charger to charge the Parkside battery.