Pi 3 Snapfit fan 40/60mm case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An alternative Model of the Pi 4 Snapfit case from @Ash. Its adjusted to match the Pi 3 and can hold an 40 or 60 mm fan.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 98
- Wydruki
- 1
- Wyświetlenia
- 603
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This model is a customized version of the Pi 4 Snapfit 60mm fan case from @ash.
I just wanted to have the cool infill look also on a case for the Raspberry Pi3, so I adjusted the holes for the plugs. There is also a 60mm and a 40mm fan variant of the top.
Also make sure the set the top and bottom layer to 0 and a 2D infill in the slicer to get the look-through look.
Note to the picture: Seems that I have a taller fan, so the edge of it lays directly on the USB ports, so its pushing a little up and causing the visible gap. Nevertheless the case keeps closed.