Customizable Stackable 1/10 Tire Rack for OpenRC

This is a remix of https://www.thingiverse.com/thing:4218345/files

I originally expanded the rack portion to the biggest that would fit on my prusa plate, and it accommodates 2 sets of my 1/18 tires per row. Then I wanted a similar solution for my OpenRC tires, but the 2017+ model with its fatter rear tires had an awkward fit on my original sizing so I resized them again. Now it accommodates 1 set per row of either the original OpenRC tire sizes (or F104s) or any of the plethora of varieties with the 2017+ rear axle. Obviously we're going to run out of room now that we only have one per row right? Naturally the next thing was to make them stackable.

I have included models for:

• a rack OpenRC-width
• a rack that I think is the maximum size you can get out of the build plate (horizontally anyway, could squeeze a little more out, one at a time diagonally!)
• Side rails that have channels up top to stack another set
• The original side rails that are rounded up top, making for easy lifting and a nicer look for your top set

Everything printed in Prusament Space Grey PLA at 0.3mm layer height with a brim and no supports. Check the included project file for print orientations.