1 / 2
Bicycle wall holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Save space and mount your bicycle to the wall using the pedals. Prints from PLA without supports.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 47
- Wydruki
- 2
- Wyświetlenia
- 685
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
Print setup
- Prints without support
- 100% infill recommended
- Please pay attention to the print orientation of the “pedal hook” on the buildplate and on the measurements of the pedal hook that has to fit your pedals.
- 0.2 mm print layer height is sufficient
- Works with standard PLA
Setup (recommendation)
- Select appropriate screws and washers
- Select dowels matching your screws
- Use the part “pedal hook” to mark your drillholes on the wall
- Drill the holes matching your selection
- Screw the pedal hook to the wall and make sure it is properly secured
- Fix two paper sheets on the wall roughly where your bike tires will touch the wall
- Hang the bike to the wall
- Put the parts “wheel support” underneath the wheels and mark their position
- Take the bike down
- Put the wheel support in the marked spot and mark the drillhole in the center of the long hole (to later be able to adjust heigth)
- Drill the holes, fix the wheel supports and hang the bike to the wall