1 / 2
Bicycle wall holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Save space and mount your bicycle to the wall using the pedals. Prints from PLA without supports.
- Rating
- 5 / 5
- Likes
- 9
- Downloads
- 47
- Makes
- 2
- Views
- 685
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
Print setup
- Prints without support
- 100% infill recommended
- Please pay attention to the print orientation of the “pedal hook” on the buildplate and on the measurements of the pedal hook that has to fit your pedals.
- 0.2 mm print layer height is sufficient
- Works with standard PLA
Setup (recommendation)
- Select appropriate screws and washers
- Select dowels matching your screws
- Use the part “pedal hook” to mark your drillholes on the wall
- Drill the holes matching your selection
- Screw the pedal hook to the wall and make sure it is properly secured
- Fix two paper sheets on the wall roughly where your bike tires will touch the wall
- Hang the bike to the wall
- Put the parts “wheel support” underneath the wheels and mark their position
- Take the bike down
- Put the wheel support in the marked spot and mark the drillhole in the center of the long hole (to later be able to adjust heigth)
- Drill the holes, fix the wheel supports and hang the bike to the wall