TIG filler rod tube dividers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Collection of 4 divider designs make to fit Blue Demon RST-36 TIG filler rod storage tubes
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 180
- Wydruki
- 0
- Wyświetlenia
- 966
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Collection of 4 divider designs make to fit Blue Demon RST-36 TIG filler rod storage tubes
2 compartment 50/50,
3 compartment 50/25/25,
3 compartment 33/33/33,
4 compartment 25/25/25/25
No special printing requirements. Did mine with a 0.6mm nozzle (what was in the printer at the time) in PLA with 15% infill. Print with outer ring down (widest part of print).
Parts are sized to snap into the tubes. For mine I flipped the tube over and placed it over the ring on the floor and pressed down while wiggling to snap them in. I had one tube I had to run a reamer around in the inside edge to remove a small amount of material to get the last one to snap in.
FreeCAD file included if you want to make alters.