1 / 3
MK5/MK6 filament plunger screw guide (anti vibration) — zdjęcie 1
1 / 3

MK5/MK6 filament plunger screw guide (anti vibration)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is for the old MK5/6 makerbot extruder

Ocena
0 / 5
Polubienia
0
Pobrania
17
Wydruki
0
Wyświetlenia
232
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This is for the old MK5/6 makerbot extruder

Print instructions

MK5/6: http://www.youtube.com/watch?v=MKfpU7ZJyJo (after)

Then, few prints and your perfect presure over the filament gets modified by this vibration. This guide removes all the problem.

Instructions

  1. Print (I used 0.4 mm nozzle, 0.3 mm layer, 60% fill)
  2. Screw the original screw, the hole is tight so I used a bit of 3-in-1 oil to make the screw thread
  3. Insert the piece and screw into near the original nut (keep the nut near this guide)
  4. Adjust the filament pressure now, it will be rock solid :)
  5. Enjoy!

Tagi