CR6 SE Filament Run Out Sensor Shim
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The extruder on my CR6 SE was terrible so I replaced it with a Winsinn dual gear extruder from amazon. This however…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 322
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
The extruder on my CR6 SE was terrible so I replaced it with a Winsinn dual gear extruder from amazon. This however lifted the path of the filament by 10mm and it was no longer in line with the filament run out sensor.
This is a 10mm shim to boost the run out sensor up to the same level as the extruder. Just remove the sensor, place this shim under it, and replace the existing M3x20 bolts with M3x30 bolts.
I have this on my printer and its working perfectly!
Print Settings
Printer:
Creality CR 6 SE
Rafts:
No
Supports:
No
Resolution:
0.28
Infill:
20%
Filament:
Overture PLA
Grey
Notes:
Printed in PLA with 5 walls to help resist compression over time
Category: 3D Printer Extruders