Minimalist Y rail endstops
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is about the smallest inline endstop I could come up with for the Y rail.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 241
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This is about the smallest inline endstop I could come up with for the Y rail. I needed the limit switch below the Y-carriage for another project I am working on. it's angled to line up with the Y belt anchor bracket for either the trinitylabs or makerstoolworks Y rails, but should also work on other projects.
As there really isn't much plastic for your anchor bolts to bite into for the Y switch mount itself, you will need some washers.
Right and left versions included, for use on either side of the rail.
Print instructions
Category: 3D Printers Summary
This is about the smallest inline endstop I could come up with for the Y rail. I needed the limit switch below the Y-carriage for another project I am working on. it's angled to line up with the Y belt anchor bracket for either the trinitylabs or makerstoolworks Y rails, but should also work on other projects.
As there really isn't much plastic for your anchor bolts to bite into for the Y switch mount itself, you will need some washers.
Right and left versions included, for use on either side of the rail.
Instructions
print it with support. I found end printing was easiest. then trim the keyway notch to fit your rail and screw it down. The Y switch is held on by bolts threaded into the plastic itself. seems to be holding up fine so far, though I may try for a nut backed one later.