Upper Gantry Cable Routing Ducts for 60mm height increase.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I have lighting cables that run on both sides of the gantry top. This lets me route them cleanly.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 238
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I have lighting cables that run on both sides of the gantry top. This lets me route them cleanly. This fits the upper gantry height extension made by Seesoe. It will not fit a stock ao-101 without that modification.
Print instructions
Category: 3D Printer Parts Summary
I have lighting cables that run on both sides of the gantry top. This lets me route them cleanly. This fits the upper gantry height extension made by Seesoe. It will not fit a stock ao-101 without that modification.
Instructions
Should print fine without support. May be a little tight depending on your gantry configuration. if so, a little sand paper should take care of that. Right and left sides are included.