Makita 18v TS100 Soldering Iron Stand with Tip Cleaner pot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
TS100 Soldering Iron Stand with Tip Cleaner pot for Makita 18v Battery
- Ocena
- 0 / 5
- Polubienia
- 35
- Pobrania
- 87
- Wydruki
- 0
- Wyświetlenia
- 1301
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of my TS100 Soldering Iron Stand with Makita 18v Adapter with the addition of an integrated tip cleaner pot for brass wool.
While not an actual remix, I took inspiration for the pot's style from Soldeirng Iron Tip Cleaner by Shooter.
Instructions below are the same as for my original stand with the exception of the tip cleaner.
--------------------------------------------------------------------------------------------------
Parts required:
Links for reference only - not affiliate. They are the exact parts I used.
- a 608z bearing for the hot end contact point. Use of an all metal bearing is recommended although I have not tried one with plastic covers.
- 4 M3x12 bolts for attaching the battery adapter to the soldering stand.
- XT60H-F Power connector. (XT60-F should also work, but will have to be glued in place.)
https://www.amazon.com/gp/product/B074PN6N4K - 1 KCD3-101 SPSD Switch to fit a 10.5x27.75mm mounting hole.
- 5mm red LED and holder to fit 8mm hole.
https://www.amazon.com/gp/product/B075H8MTXZ - 2.7kΩ resistor
- wire (I used 18awg silicon sheathed)
- battery adapter - Full or Makita Part 643852-2 for the printed adapter.
https://www.amazon.com/dp/B08F3JQ9QZ - Brass wool for the tip cleaner.
- Optional - any parts required to build an over discharge protection circuit. I'm simply relying on using Ralim IronOS with Low Voltage set to 5S, but there is an instructable for an over-dischareg protection circuit if you wish to include one.
https://www.instructables.com/Making-a-Over-Discharge-Protection-for-Makita-Batt
Print and Assembly Instructions:
Before printing the stand, please print the clearance tests to determine which fits your bearing and filament the best. These are cut from the main model to ensure the same orientation when printing. 22.10mm diameter works for me for some generic PLA and Prusament PETG, but some other PETG I had required the 22.20mm one.
Print the stand upright with selective supports where shown. You can use automatic if you wish, but the supports in my photo are the only places where they are needed.
The included battery adapter is https://www.printables.com/model/134967
If you choose to use a different battery adapter, here are the dimensions in mm.

When assembling, an XT60H-F connector will fit with slight force and be held in place without glue or epoxy once the battery adapter is secured. An XT60-F will also fit with slight force, but will require epoxy to prevent it from sliding in and out once assembled.
XT60H-F:

XT60-F

I have not prepared a wiring diagram, but other than ensuring you use a 2.5k resister in series with the LED, the photos should provide enough information.
Please let me know if you print this. If you end up using it with a different adapter or battery let me know and I will add a note and link to your adapter.