Ergodox tents (full-hand)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
angled tents for the OG full-hand ergodox
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 605
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Share Alike
I was tired of my janky tents I just velcro'd on to the bottom of my hergodox, so I made this. I chose a tent angle of 17-degrees b/c its what i had before, but using the Onhape doc, you can plug in any angle you like. I made this with 5mm diameter x 4mm deep M3 heat inserts. The holes should line up, but I wasn't able to find any official hole spacing, so I had to do what lined up with mine. YMMV. If you find anything official, and/or you have issues, I can update the model accordingly.
I printed these on the front side down. I had some warping, so one of my holes doesn't line up, so make sure your bed adhesion is excellent. But they are still solidly attached. For the other side, just mirror the model.
yes, i know my keyboard needs to be cleaned.