FLsun V400 Tool Caddy
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tool Holder for FLsun Super Racer
- Ocena
- 5 / 5
- Polubienia
- 35
- Pobrania
- 401
- Wydruki
- 3
- Wyświetlenia
- 1778
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I haven't seen a good tool holder for the V400, so I though I would build one. This is patterned off of several different models that were floating around for the Super Racer. It's not a remix, as it was built from scratch in SketchUp. I tried to include a bunch of different holes, slots and hangers, as everyone likes to put different things there. It can hold allot, as you can see be the one pic with mine semi-full loaded. I tried to keep this a little slimmer in terms of profile.
I printed this with Hatchbox Black PLA, .04 nozzle on V400, using PrusaSlicer and the 3D Print Beginner V400 PLA Standard Profile (which works awsome, BTW).
I went to 30% Gyroid fill for a little added strength (may be overkill)
No Supports Required. Should not require a brim if you first layer is good
It took the V400 about 1 Hr and 19 minutes to print
Don't try to spread the arms into the channels from the side. Go from the top and and just give them a gentle tug to get started, then slide the holder down the channel to your desired height