1 / 3
HDMI5 screen case and mount — zdjęcie 1
1 / 3

HDMI5 screen case and mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Modeled this up for my Ender3 belt conversion. Two front options - with or without sign.

Ocena
5 / 5
Polubienia
16
Pobrania
139
Wydruki
1
Wyświetlenia
1465
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

Case and mount for BTT HDMI5 screen for a 4040 extrusion end cap. There are two fronts - with or without a sign. Two signs - “Ender3 belt“ and blank. Two mounts - swivel and fixed. Both tilt. 
 

I used 90 deg connections but straight one worked too. You will need some M3x5x4 heat sets (voron spec ones), a selection of M3 bolts and a couple m3 nuts. You can reuse the M5x8 bolts that were holding the stock screen in place.  
 

The back piece has sacrificial layers in the holes that the screen mounts too so you can avoid supports. A sharp knife or a 3mm drill will clear those easily. 

Tagi