RaspberryPi Zero (2) snapfit case for ender 3 (pro) or v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
i needed a case for the raspberrypi zero. i didn't want to use screws, so its snapfit. it doesn't require any support.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 289
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
i needed a case for the raspberrypi zero. i didn't want to use screws, so its snapfit. it doesn't require any support. the parts are already rotated in the right direction. it took me a lot of time to make this, so I hope it works for other people too.
I wanned to keep it as clean as possible, so it's wired via serial. i use klipper with the fluid interface
I use the case on an ender 3 pro with klipper.
You can also add a fan it you want. i wired it to 24v, but you can also wire it to the pi zero on the 5v, if the fan is 5v. it's supposed to be a 30x30x10mm fan.