FLSun v400 - Cup/Pringles Can Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a simple rail mount to hold a pringles can or a cup on the side
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 519
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I use a pringles can as a trash can for the prime lines, and was fed up of it taking up desk space so I just made a quick mount. I also have another one that has a cup that holds filament clips.
Diameter of the circle is 75.5mm.
The fit of the can is quite tight, so you may want to punch a hole in the bottom of the mount if you're having issues removing the can.
Don't try to spread the arms into the channels from the side. Go from the top and and just give them a gentle tug to get started, then slide the holder down the channel to your desired height.
No supports or brim requried, I did around 30% gyroid infill.