Skådis hoto drill holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A holder for the hoto tools drill that is compatible with Ikea Skådis.
- Ocena
- 3 / 5
- Polubienia
- 33
- Pobrania
- 143
- Wydruki
- 2
- Wyświetlenia
- 948
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
As the description says. There are two different versions of this Holder. A regular one and one that is designed for a bit of extra padding, if you're worried about the plastic leaving marks on the rubber part of the drill (like I was). As padding, I just used a piece of 19mm wide foam tape and some white electrical tape on top of it. Orientation is probably pretty self-explanatory. Just print the halves with the flat, chamfered side facing down, this way you don't need any supports.
If you'd also like a holder for the drilling and screwing bits that came with the drill, check out My holder for those.
Printed on mk3s with mmu2s with a slightly modified .3mm draft preset using Vanilla White Prusament PLA.