1 / 1
Skadis Turris Omnia Mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount to attach a Turris Omnia router to an IKEA SKÅDIS pegboard
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 494
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This is a mount to attach the Turris Omnia open source router to an Ikea Skadis pegboard. It uses Skadis T-Nuts for secure installation. The mount creates a 5mm gap between the router and the pegboard to allow air flow.
 | Read more about the Skadis T-Nuts Mounting System and check out the Skadis T-Nuts Collection for more Skadis accessories that use T-Nuts. |
BOM
| Qty | Description | Sourcing |
|---|---|---|
| 4 | M2.5 DIN934 Hex Nut | Aliexpress |
| 4 | M2.5x12 (or longer) Socket Head Cap Screw | Aliexpress |
| 4 | M3x6 Countersunk screws (can be taken from existing Omnia housing) | Aliexpress |
Printed Parts
| Qty | Part | Download |
|---|---|---|
| 4 | Skadis T-Nut M2.5 | Download here |
| 2 | Turris Omnia Mount A | this project |
| 2 | Turris Omnia Mount B | this project |
Printing
Print the parts in the original orientation. All STL and 3MF files are pre-rotated for printing. Check out the Skadis T-Nuts page for T-Nut print settings.
Print Settings
- Material: PLA, PETG, etc.
- Layer height: 0.2mm
- Extrusion width: 0.4mm
- Perimeters: 3 or more
- Infill: 20%
Assembly
Step 1 - Preparation
- Push the M2.5 nuts into the back of the Skadis T-Nuts
- Push the M2.5x12 screw through the Mount
- Screw the T-Nut onto the M2.5 screw and leave a gap of about 2mm between the T-Nut and the Mount
- Repeat this for all 4 Mounts (2x A, 2x B)
Step 2 - Install the Mounts
- Install the mounts as shown below
- Leave 1 empty hole between the mounts horizontally and 4 empty holes vertically
- Tighten the M2.5 screws but do not overtighten
Step 3 - Install Turris Omnia
- Remove the wall mounting plate from the router if attached
- Place the Turris Omnia router between the 4 mounts
- Align the the holes
- Use the M3x6 countersunk screws to attach the router. You can reuse the screws from the router's housing.
