TonUINO 999 - Housing for the RFID Music Box TonUINO AiO
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Housing for the TonUINO RFID Music Box using the All-in-One PCB from Leiterkarten-Piraten
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 91
- Wydruki
- 0
- Wyświetlenia
- 1706
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Share Alike
This is a build of the TonUINO Project with the All-in-One PCB from Leiterkarten-Piraten. It's a Musicbox (not only) for Kids with a RFID reader. By holding a card on the top of the box, specific music will play. More information on the Project page…
It's a cube with a side length of 9 cm → 9x9x9
What you will need to build one:
- The TonUINO All-in-One PCB
- 5x Buttons
- RFID Reader
- Speaker (4 Ohm 3W 53mm)
- LiFePo-Battery
- Screws M3x12 (4x) [ISO 7380]
- Screws M3x6 (4x) [ISO 4762 or ISO 7380]
- Threaded insert M3 (8x)
- Cables to connect the Buttons
- Micro SD card
- USB-C cable
- Cable ties for mounting the Battery
Tools you need:
- Hex screw drivers
- Soldering iron ( for Speaker & Buttons)
Print Settings:
- 0.4 mm nozzle
- 0.2 mm layer height
- Infill 30%
- 3 bottom layers
- 2 top layers
- 3 layer shell thickness
- no supports
Colors:
- Color 1: Housing & Lid
- Color 2: Shell
- Any Color for RFID-Clamp
For the Lid, print the first 3 layers in Color 2 !
The Screw holes of the Lid are closed for better printing without support. They can be cutted easily. There are also imcluded support rings for the button holes, which are easy to remove after printing.
For the lower Button on the right side you have to remove (unsolder / cut off) a part from the PCB:
