1 / 1
Spacer for "BREACHER" Pico 4 VR magnetic Gunstock — zdjęcie 1

Spacer for "BREACHER" Pico 4 VR magnetic Gunstock

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Just a spacer to use 20x4mm magnets on BREACHER gun stock instead of the 30x5mm listed.

Ocena
0 / 5
Polubienia
3
Pobrania
23
Wydruki
0
Wyświetlenia
1175
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

BREACHER: https://www.printables.com/model/309498-breacher-pico-4-vr-magnetic-gunstock

V1 has the magnet sitting 1mm below the surface, V2 has it flush. 

It is probably best to use V2 both in hexaplate and controller cup to have the magnets touch and then fine tune the grip using electrical tape or smth in between. 

Having V1 on other side and V2 on the other (1mm air gap between) produces weaker grip that might be desirable. YMMV.

V1 on both sides (2mm air gap between magnets) is definitely too weak, not recommended.