Air Raid Siren - hand crank version 3.1 (fit on the printer differently)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My primary printer is a Prusa i3, and the bed size was just not enough to handle the original design.
- Ocena
- 5 / 5
- Polubienia
- 148
- Pobrania
- 777
- Wydruki
- 1
- Wyświetlenia
- 9536
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution
My primary printer is a Prusa i3, and the bed size was just not enough to handle the original design.
I had pretty good success with the 80% build by MlePh (https://www.thingiverse.com/thing:3410556), but I wanted to scale up in size. When I tried to run the model by Kaetzy (https://www.thingiverse.com/thing:3648309), the place where his design was separated was difficult to glue together, and I was not happy with the overall integrity of the end-product.
I loaded the original files up into MeshMixer, and I modified this to cut at a place where there was more surface area, and add a few supports between the two pieces. The end design seems to be pretty stable.
My printer tolerances were a bit off on the image, you will see a gap, but that was more about old filament then the core design change.
Print instructions
Category: Engineering Summary
My primary printer is a Prusa i3, and the bed size was just not enough to handle the original design.
I had pretty good success with the 80% build by MlePh (https://www.thingiverse.com/thing:3410556), but I wanted to scale up in size. When I tried to run the model by Kaetzy (https://www.thingiverse.com/thing:3648309), the place where his design was separated was difficult to glue together, and I was not happy with the overall integrity of the end-product.
I loaded the original files up into MeshMixer, and I modified this to cut at a place where there was more surface area, and add a few supports between the two pieces. The end design seems to be pretty stable.
My printer tolerances were a bit off on the image, you will see a gap, but that was more about old filament then the core design change.
Print Settings
Printer Brand: Prusa
Printer: I3 MK3S
Rafts: No
Supports: No
Resolution: .2
Infill: 20%-100%
Filament: Inland PETG Translucent Pink & Black