1 / 6
Air Raid Siren - hand crank version 3.1 (fit on the printer differently) — image 1
1 / 6

Air Raid Siren - hand crank version 3.1 (fit on the printer differently)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

My primary printer is a Prusa i3, and the bed size was just not enough to handle the original design.

Rating
5 / 5
Likes
148
Downloads
783
Makes
1
Views
9,579
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution

My primary printer is a Prusa i3, and the bed size was just not enough to handle the original design.

I had pretty good success with the 80% build by MlePh (https://www.thingiverse.com/thing:3410556), but I wanted to scale up in size. When I tried to run the model by Kaetzy (https://www.thingiverse.com/thing:3648309), the place where his design was separated was difficult to glue together, and I was not happy with the overall integrity of the end-product.

I loaded the original files up into MeshMixer, and I modified this to cut at a place where there was more surface area, and add a few supports between the two pieces. The end design seems to be pretty stable.

My printer tolerances were a bit off on the image, you will see a gap, but that was more about old filament then the core design change.

Print instructions

Category: Engineering Summary

My primary printer is a Prusa i3, and the bed size was just not enough to handle the original design.

I had pretty good success with the 80% build by MlePh (https://www.thingiverse.com/thing:3410556), but I wanted to scale up in size. When I tried to run the model by Kaetzy (https://www.thingiverse.com/thing:3648309), the place where his design was separated was difficult to glue together, and I was not happy with the overall integrity of the end-product.

I loaded the original files up into MeshMixer, and I modified this to cut at a place where there was more surface area, and add a few supports between the two pieces. The end design seems to be pretty stable.

My printer tolerances were a bit off on the image, you will see a gap, but that was more about old filament then the core design change.

Print Settings

Printer Brand: Prusa

Printer: I3 MK3S

Rafts: No

Supports: No

Resolution: .2

Infill: 20%-100%

Filament: Inland PETG Translucent Pink & Black

Tags