1 / 2
Ubiquiti Unifi Security Gateway (USG) 3P 40mm drop-in fan shroud
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fan shroud for 40mm fan (Noctua 12v preferred) to aid in cooling the Unifi USG-3P. Yes, the blue LED still works!
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 60
- Wydruki
- 2
- Wyświetlenia
- 946
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 2) (Komentarze: 2)Remiksy (0)Kolekcje (10)Powiązane
Remixed anocweb's original model in order to allow a little more room for the factory screws.
If you'd prefer using a 30mm fan, there is a STL for that on the original model's page.
I printed mine on an Ender 3 Pro, somewhat modded.
Soldered the wiring for the Noctua NF-A4x10 FLX fan directly to the barrel connector solder points on the bottom of the USG's main board.
The fan requires no hardware to attach to the shroud, it fits right in rather snug.
- Inland PLA+ was used
- .16mm layer height
- 50% infill
- tree supports (touching buildplate)
Enjoy!