Saturn 2 PSU Wall Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is just a simple wall bracket I made for my Saturn 2 PSU.
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 68
- Wydruki
- 0
- Wyświetlenia
- 456
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
This is just a quickly designed wall bracket I made at 4PM for my Saturn 2 PSU. It's got a couple of sleep-deprivation-derived design choices like the mouse ears instead of just putting mounting holes on the back plate, but it was a simple solution, and it works.
I found that setting up my Saturn 2 in an alcove, the power brick was left suspended in the air by the 24v wire. Printing one of these lets you take the strain off the wire which is good for the cable long term.
The bracket doesn't need to hold much weight, so is designed for minimal damage to the wall plus low material usage. Printed, it weighs about 32g and can be installed using 4 small 1mm nails or 1.5M self tapping machine screws. The power brick is held loosely in it's loving embrace and can be easily slid in and out for when you need to move your printer around.