Ender 3 - Filament spool holder + integrated run-out sensor.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Should fit every printer using standard 20x (Nx20) aluminum extrusion.. NB! STILL A PROTOTYPE!
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 178
- Wydruki
- 0
- Wyświetlenia
- 1533
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- GNU General Public License v3.0
Instructions
Both can be installed separately with M3x8mm screws and 20x20 M3 t-nuts. Both stand and sensors can be printed mirrored when you don't like the orientation. Current orientation : meant for standard E3, leaning inward, connected to the extruder by additional bowden tube. ( left side, facing forwards for the bowden setup, right side, facing backwards for the Direct Drive ). In both cases : bowden tube reaches around the side extrusion in order to keep it from getting into Z lead screw's or X toolhead's way. Compatible with my other models.
Example print in photos
ABS, 0.2mm; 4x wall/top/bottom layers, 20% infill.
Additional hardware needed:
| FILAMENT ROLL HOLDER | ||
| Name | Amount | Comments |
| M8 bolt 100mm (DIN931) | 1 | |
| M8 Nyloc nut | 1 | |
| Bearing spacers (ID 8mm, OD 10-12mm) | 2 | Printable model available. |
| M3 8mm screw | 2 | |
| M3 20x20 T-nut | 2 | |
| 688RS bearings (8x15x5mm) | 2 | |
| FILAMENT SENSOR with Creality endstop module | ||
| Name | Amount | Comments |
| Creality endstop module | 1 | Use Z endstop if you use ABL |
| M3 8mm screw | 3 | |
| Pneumatic connector with m6 thread | 1 (2) | Can be used on both ends |
| FILAMENT SENSOR with off the self microswitch | ||
| Name | Amount | Comments |
| Microswitch (6x6x13mm body) | 1 | |
| M3 8mm screw | 3 | |
| M2 10mm selftapping screw | 2 | |
| Pneumatic connector with m6 thread | 1 (2) | Can be used on both ends |